试论天津市农业污染防治地方环境标准的制定

文章通过对当前天津市农业源污染现状的分析,阐明了天津市农业污染防治地方环境标准制定的意义与必要性。在研究了国家、环境保护部及地方关于农业源水环境污染防治标准制定现状的基础上,进一步结合天津市农业源污染的实际情况,有针对性地提出天津市农业污染防治地方环境标准研究与制定工作的具体建议,以及对标准实施方面的一些看法。     

祁东经济开发区生态化建设规划研究

工业园生态化建设是发展循环经济走新型工业化道路的重要途径,生态工业园是我国继经济技术开发区、高新技术开发区之后第三代工业园区发展的必然趋势。本文从祁东经济开发区的内部资源和外部环境出发,对其发展生态工业园具备的优势与劣势、面临的机遇与威胁进行了系统分析,并对其建设生态工业园的模式和实施层次进行了探讨,同时提出了相应的保障措施,以利于祁东经开区的可持续发展。     

自由基对工业化纤废水氧化处理的研究

通过芬顿试剂氧化、次氯酸钠氧化、过氧化氢和光催化氧化方法对化纤废水进行了处理,并通过COD检测、紫外可见光光度计等方法对氧化效果进行分析。结果显示自由基氧化对化纤废水的色度减小非常明显,能使其色度从800多倍减少到10倍以下,COD值从3 550 mg/L降解到100 mg/L以下,透光率的变化率达到98.59%。化学处理工艺的探讨发现在pH值4～6,搅拌速度为1 500 r/min,处理30 min就能使废水的COD去除率达到95.67%;pH为4时过氧化氢的氧化效果最佳。利用过氧化氢和次氯酸钠的氧化获得了自由基氧化处理此类废水的基本原理,即自由基氧化和链式反应的持续发生造成了有机物的降解,少量自由基的生成某种程度上刺激了高级氧化反应的深入,同时极少量自由基的交联可能会湮灭氧化反应,不同类自由基之间形成竞争,可能影响其氧化性能的发挥,因此需要通过控制反应物的种类、用量和有效分离反应中间产物,可以达到高级氧化反应处理此种废水的最佳效果。     

石油污染对海洋生态环境的影响与防治对策

分析了石油污染对海洋生态环境的影响,提出了预防泄漏措施.     

养殖废水新型处理技术中试

针对畜禽养殖污染废水传统处理方法效率不高、噪声较大等缺点进行改进,采用"水解酸化池-塔式膜生物反应器-悬浮澄清池"工艺进行处理,结果表明:COD、氨氮去除率分别为97.5%和91%,出水水质可达GB 18596—2001《畜禽养殖污染物排放标准》。     

北湖流域水质改善系统动力学研究

利用系统动力学擅长研究动态、非线性复杂系统的特点,将其应用于北湖水质改善分析,构建了系统动力学-水质耦合模型,可实现长时间序列的连续模拟和水环境管理的情景分析。文章定量分析了三产比例调整、城镇化率提高与污水集中处理等因素对流域纳污控制及水质改善的影响,推演出可协调经济发展-水环境保护-污水治理资金三方矛盾的合理方案,为类似小城镇的发展提供可借鉴的思路和方法。     

生物滴滤塔处理制革恶臭气体微生物特性研究

在生物滴滤塔处理制革恶臭气体中,采用SBR法对活性污泥进行驯化,考查生物滴滤塔处理制革恶臭气体中微生物的特性。研究了微生物对氨氮和硫化物的去除效率以及驯化过程中污泥容积指数(SVI)的变化,并对挂膜后填料表面的微生物相进行扫描电镜观察。结果表明:经过19 d的驯化,微生物对氨氮和硫化物的去除率分别可以达到98.29%和94.16%,驯化期间污泥容积指数均保持在正常的范围之中。挂膜14 d的扫描电镜显示,填料表面有均匀的生物膜分布,说明微生物在填料上已经挂膜成功,驯化的微生物可以达到去除制革恶臭气体的要求。     

适冷微生物研究进展及应用现状

适冷微生物(包括嗜冷微生物、耐冷微生物)是在低温下仍具有生存和繁殖的能力的一类微生物,低温会对微生物产生如酶活性降低、膜流动性变差、蛋白质冷变性、不适当的蛋白质空间折叠和低温下细胞内部构造破坏等不利影响。适冷微生物能克服低温带来的消极影响,并能在极端环境下生长及代谢。随着宏基因组测序、蛋白质组学以及其它分析手段在环境微生物中的应用,作者对低温微生物的一些适应性改变有了新的认识。酶活性中心结构的改变、膜中脂质成分含量的增加,冷适应蛋白的快速表达等都被证明在对低温适应中起着重要作用。文章综述了适冷微生物的适冷机理及其在污染控制领域的应用,为适冷微生物的实际工程应用提供参考,为适冷微生物在环境工程中的进一步广泛应用奠定基础。     

Three-dimensional hydrodynamic and water quality model for TMDL development of Lake Fuxian, China

Lake Fuxian is the largest deep freshwater lake in China. Although its average water quality meets Class I of the China National Water Quality Standard (CNWQS), i.e., GB3838-2002, monitoring data indicate that the water quality approaches the Class II threshold in some areas. Thus it is urgent to reduce the watershed load through the total maximum daily load (TMDL) program. A three-dimensional hydrodynamic and water quality model was developed for Lake Fuxian, simulating flow circulation and pollutant fate and transport. The model development process consists of several steps, including grid generation, initial and boundary condition configurations, and model calibration processes. The model accurately reproduced the observed water surface elevation, spatiotemporal variations in temperature, and total nitrogen (TN), total phosphorus (TP), and chemical oxygen demand (COD) concentrations, suggesting a reasonable numerical representation of the prototype system for further TMDL analyses. The TMDL was calculated using two interpretations of the water quality standards for Class I of the CNWQS based on the maximum instantaneous surface and annual average surface water concentrations. Analysis of the first scenario indicated that the TN, TP and COD loads should be reduced by 66%, 68% and 57%, respectively. Water quality was the highest priority; however, local economic development and cost feasibility for load reduction can pose significant issues. In the second interpretation, the model results showed that, under the existing conditions, the average water quality meets the Class I standard and therefore load reduction is unnecessary. Future studies are needed to conduct risk and cost assessments for realistic decision-making.     

Fractionation of residual Al in natural water treatment from reservoir with poly-aluminum-silicate-chloride (PASiC): Effect of OH/Al, Si/Al molar ratios and initial pH

An aluminum fractionation study was conducted for a surface reservoir water treatment to understand the performance of poly-aluminum-silicate-chloride (PASiC) in terms of the residual Al fractions as a function of initial pH. The coagulation performance expressed as turbidity and organic matter removal was established as supporting data. Some extra data were evaluated in terms of the residual Al ratio of the composite PASiC coagulant. The main residual Al sources were the Al fractions derived from the use of PASiC. The turbidity and organic matter removal ability was optimal at initial pH 6.00-7.00, while the concentrations of various residual Al species and the residual Al ratio of PASiC were minimal at an initial pH range of 7.00-8.00. Under the conditions of OH/Al molar ratio = 2.00 and Si/Al molar ratio = 0.05, PASiC had superior coagulation performance and comparatively low residual Al concentrations. The Al fraction in the composite PASiC coagulant seldom remained under such conditions. Experimental data also indicated that the suspended (filterable) Al fraction was the dominant species, and organic-bound or organo-Al complex Al was considered to be the major species of dissolved Al in water treated by PASiC coagulation. Additionally, the dissolved inorganic monomeric Al species dominated the dissolved monomeric Al fraction.